It can measure flying altitude, attitude and therefore can be used for autopilot/automatic control. It contains inner damping, controllers, 3-axis gyroscope, 3-axis accelerometer and barometer in its light and small Main Controller. The innovative All-in-one design simplifies installation and saves space and weight. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M. Hovering precision(GPS mode) vertical direction:☐.By introducing the product DJI NAZA-M Lite V1.1 with GPS Kit, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. The default parameter settings are OK for you to achieve a normal flight, and it also supports remote parameter adjustment by using a control slider on the TX during flight, in order to obtain better performance.The system will adjust the gimbal and camera according to the attitude of the aircraft after setting the parameters the first time. The gimbal stabilization module is compatible with almost all 2-axis gimbal systems.Naza-M Lite now supports six types of multi-rotor, which meets the different needs of the enthusiasts.PPM & S-Bus receivers (the general use of the first 8 channels of S-Bus receiver) to optimize the channel connection, the A, E, T, R, U five-channel functions are set using channel X2, use only one servo cable to connect the PPM or S-Bus to X2, this makes installation quick and easy, not easy to make mistakes.Minimum Four channel receiver supported, also PPM and Futaba S-Bus receiver supported.In manual mode when low voltage protection is triggered the LED warning will be active only. The first level will blink the red light continuously the second level will blink red light continuously and the multi-rotor will descend and land. Both levels of protection have LED warning as default. You can choose not to use this, however we strongly recommend you to enable the protection. In order to prevent your multi-rotor from crashing or other harmful consequences caused by low battery voltage, we have designed two levels of low voltage protection.Mode by default without the failsafe function. If your transmitter has only 4 channels, then MC will work in Atti. If the GPS module is used, you can also set RTH on failsafe. Naza controller has built-in auto level failsafe function, which means when the communication between MC and the transmitter is disconnected, the outputs of all command sticks from controller will go to center position. If your transmitter supports failsafe, then you can set failsafe through port-U.
0 Comments
Leave a Reply. |